SOLO - Autonomous device
Autonomous Security Monitoring of an Integrated Warning, Fire Protection, and Emergency Evacuation System

Technical specification:
SOLO 1
Solitary storage unit (system technology enclosure)
Weather resistance IP 65. IK 5-10 max.
Patented CZ 308402 B6 – The solitary storage unit is a structural part of the solution.
Made of:
Al alloy ENAC-47100 ENAC-AlSi12Cu1(Fe) (DieCasting),
Polymer - Polymax PTEG – EDS antistatic for El. devices. Material operating temperature 85°C.
High resistance to UV radiation in the wavelength range 300-340 nm in UVA and UVB spectrum
Mechanically or magnetically fixed to the structure. Magnet minimum holding force 52 kg.
RADIAL connector for autonomous power supply from own PV cell.
RADIAL connector for charging from 230V grid + data
Cable for LV + data from central source. Connected with a single connector. Length as specified.
Cable end equipped with a 230V and data terminal block.
Integrated system equipment
Battery for powering integrated system equipment – up to 24h discharge.
Charging: Autonomously from the PV cell mounted on the enclosure – continuously. From 230V grid.
Wifi -2.46 / 5G with central management capability 802.11r/ CapsMan, virtual AP.
Fire detector EPS, e.g. Siemens – Smoke detector DELTA reflex SD230N with own battery with
possibility of connection to another El. source including integration with own central system
Shock detection sensor.
Detection of chemical warfare agents.
Hikvision camera capable of PTZ or 360 degrees Codec H. 265+ compatible with
Hikvision IVMS 4200 software, Ateas security 514.
Emergency LED lighting 2x2W with asymmetric optics powered by battery.
Data connection switch, features VLAN support, POE, 48 volt, 802.3, AF/AT or higher
supports remote lighting control over POE data network. For this connection, the RADIAL connector for charging and data transmission from the central source can be used, including cable as per above specification.
Alarm: emergency alarm trigger button.
* The device complies with legislative requirements of Act No. 22/1997 Coll. on technical requirements for products.
** The device is compliant with ČSN 33 2000-7-710 - Low voltage electrical installations - Part 7-710: Requirements for special installations or locations - Medical locations.
*** The device complies with the requirements of ČSN EN 61000-1-2 - Electromagnetic compatibility (EMC) – with extension to ČSN EN 60601-1-2 ED.2 – Electromagnetic compatibility of medical devices.
Visual documentation and pricing available upon request.